Dialing Plan - Nortel ICS Install Manual

Press ' to scroll through the five CAP/KIM
positions.
Tips -
four or fewer KIMs. If the KIMs are designated as eKIMS, you can
only attach a maximum of four modules to a 7316E. Add a SAPS
if more than four OKIMs are added to the 7316E.
If you replace a legacy 7324+CAP unit with a 7316E+KIM, only
the line assignments are copied to the new telephone, but not to the
KIM. The telephone programming will revert to the default
settings. If you move an OKIM from one 7316E to another, the
KIM will retain memory button programming. However, if you
move an eKIM from one 7316E to another, programming will not
follow

Dialing Plan

The dialing plan acts as a system directive that determines how
a number will be dialed out by the system. This feature works
with enbloc dialing, and, therefore, is only used for PRI lines.
The Dialing Plan has these features:
• allows public or private routing for network calls
• private routing allows the choice of either the uniform
dialing plan (UDP) or a coordinated dialing plan (CDP)
• allows enbloc dialing by buffering user-dialed digits until
a complete DN has been dialed. Enbloc dialing is the
default for PRI. However, you can specify Overlap Dialing
where you require a break in a dialing sequence to wait for
a PRI line-generated dialtone.
• provides the ability to map user-dialed digits to a service
type on a Call by Call basis
• allows incoming calls to be routed according to the service
type and the digits received
N0130943 02
A SAPs is not required for 7316E digital phones with
System prgrming / 451
Installer password required
Modular ICS 7.1 Installer Guide