Cap/Kim Assign - Nortel ICS Install Manual
Nortel norstar ics software: install guide
Hide thumbs
Also See for ICS:
- Quick start manual (36 pages) ,
- Supplementary manual (6 pages) ,
- User manual (138 pages)
Table of Contents
Advertisement
450 / System prgrming
CAP/KIM assign
This setting designates a telephone as an enhanced central
answering position (eCAP). A maximum of five designated
eCAPs can be installed in a Modular ICS system. The system
can support more CAP configurations that are not designated
in programming as eCAPs. Refer to the Tips below for
information about the difference between OKIMs and eKIMs.
•
Key indicator modules (KIMs). KIMs that are attached to
7316E digital phones that have been designated as eCAPs
are called eKIMs.
A 7316E+KIM which is not assigned with the DN of the
telephone under CAP/KIM assgn, is called an ordinary
KIM (OKIM). OKims support memory button
programming, only.
•
Legacy hardware: Existing systems may have 7324 digital
phones attached to CAP modules.
The eCAP can be used to:
•
monitor the busy/not busy and Do Not Disturb status of
system telephones
•
answer external calls on up to112 lines on a 7316E+eKIM
and extend calls to other system telephones
•
send up to 30 messages to other system telephones
•
provide extra memory buttons for the telephones
•
eKIMs can also support multiple appearances of a target
lines and Hunt group designators.
Use ≠, CHANGE and the dialpad to enter the internal
number of the telephone.
Modular ICS 7.1 Installer Guide
Installer password required
N0130943 02
Advertisement
Table of Contents
Troubleshooting
