Nortel ICS Install Manual page 234

234 / Mounting the modules
1. Secure a 19 mm wood backboard to a wall. It must be
capable of supporting a 20 kg mass.
2. Position the module mounting bracket on the backboard,
smooth side against the backboard, with the screw holes at
the top. Ensure that the bracket is level.
3. Fasten the bracket to the backboard with two 3/4-inch
No. 10 round head wood screws through the inner pair of
holes. The other two holes are optional.
4. Slide the module down onto the center bracket flange. Line
up the notches on the far side of the bracket to the flanges
on the module.
5. Open the front cable trough door. Fasten the bottom of the
module to the backboard.
Use two 3/4-inch No. 10 round head wood screws through
the screw holes on each side of the cable trough.
See T1 or ISDN-PRI configurations on page 524 for
configurations of Trunk Cartridges on the ICS slots.
Feature
cartridge
slot
ICS
Modular ICS 7.1 Installer Guide
ICS slots
1 2 3 4 1 2 3
TM
N0130943 02