Program A Line Pool Feature Code; Line Buttons; Select How You Dial Your Calls; Standard Dial - Nortel Business Communications Manager 2.5 Programming Manual

Telephone features programming
Table of Contents

Advertisement

42
Chapter 3 Make a call

Program a line pool feature code

When you program a button with the line pool feature code, you must enter a line pool access code
after the feature code. The programmed line pool button accesses a specific line pool, not the line
pool feature. See
If you program a button with an indicator to access a line pool, the indicator for the line pool
button turns on when all the lines in a line pool are busy. The indicator turns off when a line
becomes available.

Line buttons

There is one line button for each line assigned to your telephone. Press the line button to select the
line you want to answer or use to make a call. As you have several line buttons, you can access
more than one line.
The T7100 telephone has two intercom paths, instead of line buttons, to answer and make calls. A
T7100 can have two lines. You can press ≥ to switch between two calls, one active and one on
hold.

Select how you dial your calls

To select a dialing mode:
Press ≤•°¤.
1
Press £ or
2
Press ≤ or
3
You cannot program the dialing modes feature code on a memory button.

Standard dial

Standard dial allows you to make a call by selecting a line and dialing the number. If you have a
prime line, it is selected automatically when you lift the handset or press the handsfree button.
You cannot use Standard dial on a T7100 telephone unless you pick up the handset first. If you
have a T7100 telephone, use the Automatic dial or Pre-dial feature for on-hook dialing.

Automatic dial

Automatic dial allows you to dial a number without selecting a line. Your prime line is selected
when you start dialing a number. Automatic dial does not work if your telephone has no prime line
or when your prime line is in use.
Telephones connected to an Analog Terminal Adaptor (ATA2) or an Analog Station Module
(ASM) cannot use Automatic dial.
P0937240 02
"Programming feature codes" on page 85
NEXT
until the dialing mode you want appears.
OK
to select the dialing mode.
for more information.

Advertisement

Table of Contents
loading

Table of Contents