Rep 10.3 Front Duplex Guide Assembly - Xerox Phaser 3635MFP Service Manual

REP 10.3 Front Duplex Guide Assembly

Parts List on PL 10.22
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to
1. Remove tray 1.
2. Remove the duplex assembly, PL 10.23 Item
3. Remove the DADF, PL 5.10 Item 1.
4. Remove the print cartridge, PL 9.10 Item
5. Carefully lift the machine so that it rests on the rear cover.
6. Remove the (front) bottom cross bar to facilitate access to the front duplex guide assem-
bly, PL 8.15 Item 2.
7. Remove the tray 1 pick-up roll, PL 10.22 Item 14
shaft.
Repairs and Adjustments
REP 10.3
CAUTION
GP 10 General Disassembly Precautions.
18.
1.
by releasing the tab from the notch in the
8. Prepare to remove the front duplex guide assembly,
April 2010
4-30
Figure 1.
2
Slide the shaft to the right to disengage the
cam from the follower.
1
Remove the
KL-clip.
Figure 1 Preparation
Phaser 3635MFP/WorkCentre 3550