Table of Contents
Advertisement
TRENDnet User's Guide
•
Priority: Indicates the port priority. If two paths have the same port cost, the
bridges must select a preferred path. In some instances this can involve the use
of the port priority parameter which is used as a tie breaker when two paths
have the same cost. The range for port priority is 0 to 240. As with bridge
priority, this range is broken into increments, in this case multiples of 16. To
select a port priority for a port, you enter the desired value. Table 1 lists the
values that are valid.
Path Cost: This defines a metric that indicates the relative cost of forwarding
•
packets to the specified port list. Port cost can be set automatically or as a
metric value. Define a value between 1 and 200000000 to determine the
external cost. The lower the number, the greater the probability the port will
be chosen to forward packets. The default port cost: 100Mbps port = 200000.
Gigabit port = 20000.
Edge Port Conf/Oper: Indicates if a port is connected to an edge device in the
•
network topology or not. Select Yes designates the port is an edge port, and No
to designate the port is not an edge port.
•
P2P MAC Conf/Oper: P2P ports are similar to edge ports, however, they are
restricted in that a P2P port must operate in full-duplex. Auto allows the port
to have P2P status whenever possible and operate as if the P2P status were
true. Selecting Yes indicates a P2P shared link is available. Selecting No means
the port cannot maintain a P2P link.
•
Migration: Enabled indicates the port is configured to accept RSTP and
Disabled indicates the port is not configured to accept RSTP.
•
Status: Select Enabled to enable the status to be shown or Disabled to disable
this feature.
MST
Network > Spanning Tree > MST Instance Settings
1. Log into your switch management page (see
on page 9).
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your switch management
page"
2. Click on System, click on Spanning Tree, and click on MST Instance Settings.
3. Click on Add to add a new entry.
4. Review the settings. For each section, click Apply to save changes.
MST Configuration Identification Settings
•
Configuration Name: A configured name set on the switch to uniquely identify
the MSTI (Multiple Spanning Tree Instance). If a configuration name is not set,
this field shows the MAC address of the device running MSTP.
•
Revision Level (0-65535): This value, together with the configuration name,
and identical vlans mapped for STP instance IDs identifies the MST region
configured on the switch.
MST Instance Settings
MSTI ID: Displays the MST ID associated with the VID List. The possible field
•
range is 1-4.
VLAN List: Displays the VID List.
•
•
Priority: Select the new priority in the Priority field from the drop down menu
options. The user may set a priority value between 0-61440.
TL2-F7120
40
Advertisement
Table of Contents
