Configure Spanning Tree Protocol Mst Settings (Mstp) - TRENDnet TPE-1020WS User Manual

TRENDnet User's Guide

Configure Spanning Tree Protocol MST settings (MSTP)

Bridge > Spanning Tree > MST Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on Spanning Tree, and click on MST Settings.
3. Review the settings. For each section, click Apply to save changes.
MST Configuration Identification Settings
•
Configuration Name: A configured name set on the switch to uniquely identify
the MSTI (Multiple Spanning Tree Instance). If a configuration name is not set,
this field shows the MAC address of the device running MSTP.
•
Revision Level (0-65535): This value, together with the configuration name,
and identical vlans mapped for STP instance IDs identifies the MST region
configured on the switch.
MST Instance Settings
• MSTI ID (1 - 31): Displays the MSTI ID associated with the VID List. The possible
field range is 1-31.
• VID List (1 - 4094): Displays the VID List. Click Add to add into MST Table below.
•
Priority: Enter the new priority in the Priority field. The user may set a priority
value between 0-61440.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"
•
MST Table: Make changes to the table entry, and click Apply modify or click
Delete to remove the ID entry.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-1020WS
28