TRENDnet User's Guide
Command Objective
Syntax
Parameter
Description
Mode
Copyright 2023 TRENDnet. All Rights Reserved.
This command is used to set the send or receive flow-control value for an
interface.
flowcontrol { on | off }
•
on
- If used with receive allows an interface to operate with the
attached device to send flow control packets. If used with send the
interface sends flowcontrol packets to a remote device if the
device supports it
•
off
- Turns-off the attached devices (when used with receive) or the
local ports (when used with send) ability to send flow-control packets
to an interface or to a remote device respectively.
Interface Configuration Mode
TL2-F7120