TRENDnet TL2-F7120 User Manual page 24

TRENDnet User's Guide
Configure the system time and date settings
System > System Settings > System Time
1. Log into your switch management page (see
on page 9).
2. Click on System, click System Settings and click System Time.
Current Time: Displays the current system time and date.
•
SNTP: Select enabled to obtain time and date settings from an SNTP server.
•
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your switch management page"
Note: Ensure that the correct IP default gateway and DNS configuration are
correct for the switch to reach the Internet and resolve host names settings
before enable SNTP.
• Manual Time: If SNTP is not used to obtain time and settings, you can manually
enter the time and date settings in this section.
Time Zone: Click the drop-down list to select your time zone which can be set
•
by country or offset. This must be selected for both SNTP and manual time
settings.
Daylight Savings Time: If daylight savings time applies to your region, click the
•
drop-down list and select Recurring, then specify the time period when daylight
savings time should be applied in the Recurring From and Recurring To fields
provided. This can be set for either SNTP or Manual time configuration.
• SNTP/NTP Server Address: If using SNTP, enter the primary SNTP or NTP server
IP address or hostname.
Note: Ensure that the correct IP default gateway and DNS configuration are
correct for the switch to reach the Internet and resolve host names settings
before enable SNTP.
Server Port: If using SNTP, enter the primary SNTP server port. Default is 123.
•
SNTP/NTP Server Address2: If using SNTP, enter the secondary SNTP or NTP
•
server IP address or hostname.
Note: Ensure that the correct IP default gateway and DNS configuration are
correct for the switch to reach the Internet and resolve host names settings
before enable SNTP.
Server Port2: If using SNTP, enter the secondary SNTP server port. Default is
•
123.
Click Apply to save the configuration settings.
TL2-F7120
20