TRENDnet TL2-F7120 User Manual page 373

TRENDnet User's Guide
Command Objective
✏
Copyright 2023 TRENDnet. All Rights Reserved.
This command enables automatic detection of Edge port parameter
of an interface.
The no form of this command disables automatic detection of Edge port
parameter of an interface. The automatic detection of Edge port parameter
is disabled, even if the spanning tree Mode is changed.
Once automatic detection is enabled, the Edge port parameter is
automatically detected and set. The port is set as edge port, if no BPDU is
received on the port. The port is set as non-edge
port, if any BPDU is received.
The automatic detection of Edge port parameter can be configured in the
switch, only if the spanning tree functionality is not shutdown in the switch.
The type of spanning tree Mode should be set, if the functionality is already
shutdown.
TL2-F7120