Table of Contents
Advertisement
TRENDnet User's Guide
Create additional IPv6 address interfaces
System > System Settings > IP Settings > IPv6 Network
The switch supports layer 3 network features such as static IPv4/IPv6 routing and inter-
VLAN routing but not dynamic routing protocols. This section allows you to create
additional IPv6 address interfaces and assign to VLAN interfaces.
1. Log into your switch management page (see
on page 9).
2. Click on System, click System Settings, click IP Settings, and click on IPv6 Network.
3. To add a new IPv6 address interface and assign to a VLAN, click Add.
Note: Before you can assign IPv6 address interfaces to VLANs, you must create
additional VLAN first. You can create VLANs under the Network > VLAN section.
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your switch management
page"
•
VLAN ID: Click the drop-down list to select a VLAN ID to assign the IPv6 address
interface.
•
Address: Enter the IPv6 address to assign to the VLAN. (ex: 192.168.20.254)
•
Prefix Length: Enter the IPv6 prefix length.
Click Apply to save the settings.
Note: After the IPv4 address interface is assigned to the VLAN, the local interface route is
created automatically. Also, note that interface routes are not active until a physical link
to the VLAN interface is detected on the switch.
TL2-F7120
17
Advertisement
Table of Contents
