TRENDnet TL2-F7120 User Manual page 362

TRENDnet User's Guide
4.1.91 spanning-tree mst hello-time
Command Objective
✏
Syntax
Mode
Copyright 2023 TRENDnet. All Rights Reserved.
This command configures the spanning tree hello time.
The no form of this command resets the hello time to its default
value.
The hello time represents the time interval (in seconds) between two
successive configuration BPDUs generated by the switch on the port. This
value is either 1 or 2 seconds. This value is applied to all active MSTIs.
This command can be executed successfully, only if the spanning tree
functionality is not shutdown in the switch. The type of spanning tree
Mode should be set as mst.
spanning-tree mst hello-time<value(1-2)>
no spanning-tree mst hello-time
Global Configuration Mode
TL2-F7120