Table of Contents
Advertisement
TRENDnet User's Guide
Jumbo Frame
Sends larger packets, or Jumbo Frames (up to 9KB) for increased performance
Rackmount Design
Save rack space by mounting 2 x TL2-F7120 into 1U space with the optional ETH-F71
dual mount bracket (sold separately)
IPv6 Ready
This 10G SFP+ switch supports Ipv6 configuration and Ipv6 neighbor discovery
IP Routing
Supports inter-VLAN routing and Ipv4/Ipv6 static routing
Traffic Management
A broad range of network configurations are supported by this 10G managed SFP+
switch: 802.1ax link aggregation, , 802.1Q VLAN, Voice VLAN, RSTP, MSTP, Loopback
Detection, GVRP, 802.1p Class of Service (CoS), port bandwidth management, and QoS
queue scheduling
Troubleshooting
A convenient cable diagnostic test and traffic statistics aid in network troubleshooting
Access Control
Features such as IPv4/IPv6 ACL, port security (mac entry restriction), 802.1X, TACACS+,
and RADIUS are compatible with layered access controls
Monitoring
RMON, SNMP, SNMP Trap, and Port Mirroring, and DDM are supported on the 10G SFP+
switch
© Copyright 2023 TRENDnet. All Rights Reserved.
Product Hardware Features
•
AC Power Connector – Connect the AC power cord to the connector and
the other side into a power outlet. (Input: 100~240VAC, 50/60Hz)
•
Reset Button – Press and hold this button for 15 seconds and release to
reset the switch to factory defaults.
•
10G SFP+ Slots (1-12) – Supports 1000BASE-X (Gigabit Ethernet over
fiber) or 10GBASE-X (10 Gigabit Ethernet over fiber SFP/mini-GBIC
modules for connectivity.
•
Console port – Use the included RJ-45 to RS-232 serial console cable to
access the out-of-band command line interface management.
TL2-F7120
2
Advertisement
Table of Contents
