Table of Contents
Advertisement
TRENDnet User's Guide
There are two methods that can be used to reboot your switch.
Hardware Method: Using a paper clip, on the front panel of the switch, push
•
and hold the Reset button between 1~5 seconds and release.
Software Method (Switch Management Page):
•
1. Log into your switch management page (see
on page 9).
2. Click on your profile in the top right corner.
3. Click Reboot drop-down list. Wait for the switch complete the rebooting process.
To reset your switch to factory defaults:
You may want to reset your switch to factory defaults if you are encountering difficulties
with your switch and have attempted all other troubleshooting. Before you reset your
switch to defaults, if possible, you should backup your switch configuration first, see
"Backup/Restore" on page 88.
There are two methods that can be used to reset your switch to factory defaults.
•
Hardware Method: Using a paper clip, on the front panel of the switch, push
and hold the Reset button more than 6 seconds and release. Located on the
front panel of your switch, see "Product Hardware Features" on page 2. Use
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your switch management
page"
this method if you are encountering difficulties with accessing your switch
management page.
Software Method (Switch Management Page):
•
•
1. Log into your switch management page (see
management
page" on page 9).
2. Click on your profile in the top right corner.
3. Click Reset from the drop-down list. Clicking Reset, will automatically reset the switch
back to its factory default settings.
The switch's factory default settings are below.
Administrator User Name
Administrator Password
Switch IP Address
Switch Subnet Mask
TL2-F7120
"Access your switch
admin
admin
192.168.10.200
255.255.255.0
72
Advertisement
Table of Contents
