Advanced Firewall Dmz Service Configuration - Cisco OL-4015-08 User Manual

Advanced Firewall Configuration Wizard

Advanced Firewall DMZ Service Configuration

DMZ Service Configuration
To configure a DMZ service entry:
To edit a DMZ service entry:
Cisco Router and Security Device Manager Version 2.2 User's Guide
5-6
This window allows you to view rule entries that specify which services available
inside the DMZ you want to make available through the router's outside
interfaces. Traffic of the specified service types will be allowed through the
outside interfaces into the DMZ network.
This area shows the DMZ service entries configured on the router.
Start IP Address
The first IP address in the range that specifies the hosts in the DMZ network.
End IP Address
The last IP address in the range that specifies the hosts in the DMZ network. If
there is no value listed in this column, the IP address in the Start IP address
column is presumed to be the only host in the DMZ network. The range can
specify a maximum of 254 hosts.
Service Type
The type of service, either Transmission Control Protocol (TCP) or User
Datagram Protocol (UDP).
Service
The name of the service, such as Telnet, or FTP, or a protocol number.
Click Add, and create the entry in the DMZ Service Configuration window.
Select the service entry, and click Edit. Then, edit the entry in the DMZ Service
Configuration window.
Chapter 5 Create Firewall
OL-4015-08