Cisco OL-4015-08 User Manual page 175

Chapter 7 Application Security
HTTP
Detect non-compliant HTTP traffic Checkbox
Detect tunneling applications Checkbox
OL-4015-08
Reset
Resets the TCP connection if the client enters a non-protocol command before
authentication is complete.
Router Traffic
Enables inspection of traffic destined to or originated from a router. Applicable
only for H.323, TCP, and UDP protocols.
Specify general settings for HTTP traffic inspection in this window. To learn
about the buttons and drawers available in the Application Security tab, click
Application Security Windows.
Click Permit, Block, and Alarm Controls
the router is to take when it encounters traffic with the characteristics that you
specify in this window.
For more detailed information about how the router can inspect HTTP traffic,
refer to the document at the following link:
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_ch
apter09186a0080455acb.html
Check this box if you want SDM to examine HTTP traffic for packets that do not
comply with the HTTP protocol. Use the Permit, Block and Alarm controls to
specify the action that you want SDM to take when this type of traffic is
encountered.
Check this box if you want SDM to examine HTTP traffic for packets that are
generated by tunneling applications. Use the Permit, Block and Alarm controls to
specify the action that you want SDM to take when this type of traffic is
encountered.
Cisco Router and Security Device Manager Version 2.2 User's Guide
to learn how to specify the action that
HTTP
7-21