Add Or Edit Static Address Translation Rule: Outside To Inside - Cisco OL-4015-08 User Manual

Network Address Translation Rules
Redirect Port
Configuration Scenarios

Add or Edit Static Address Translation Rule: Outside to Inside

Cisco Router and Security Device Manager Version 2.2 User's Guide
18-20
If you are mapping the inside local addresses of a subnet to the corresponding
•
inside global addresses, enter any IP address that you want to use in the
translation in this field. The network mask entered in the Translate from...
Interface area will be used to calculate the remaining inside global addresses.
If you do not enter a network mask in the Translate from Interface
Note
area, SDM will perform only one translation.
Check this box if you want to include port information for the inside device in the
translation. This enables you to use the same public IP address for multiple
devices, as long as the port specified for each device is different. You must create
an entry for each port mapping that you want to make for this "Translated to"
address.
Click TCP if this is a TCP port number; click UDP if it is a UDP port number.
Original Port. Enter the port number on the inside device.
Translated Port. Enter the port number that the router is to use for this
translation.
Click Static Address Translation Scenarios
fields in this window are used.
Use this help topic when you have chosen direction From Outside to Inside in
the Add or the Edit Static Address Translation Rule window.
Use this window to add or edit a static address translation rule. If you are editing
a rule then the rule type, static or dynamic, and the direction are disabled. If you
need to change these settings, delete the rule, and recreate it using the settings you
want.
There are two types of static address translations using NAT, simple static and
extended static.
Chapter 18 Network Address Translation
for examples that illustrate how the
OL-4015-08