Add Or Edit Bvi Interface; Add Loopback Interface/Connection—Loopback - Cisco OL-4015-08 User Manual

Add or Edit BVI Interface

Note
Add, Edit, and Delete Buttons
Add or Edit BVI Interface
IP Address/Subnet Mask
Add Loopback Interface/Connection—Loopback
IP Address
Cisco Router and Security Device Manager Version 2.2 User's Guide
4-18
In this example, FastEthernet1.5 is configured for routing, and FastEthernet1.3 is
configured for IRB.
You must choose the physical interface on which the subinterfaces are configured
to display this window. For the example described, you would have to choose
FastEthernet 1 to display this window. If you chose FastEthernet1.3 or
FastEthernet1.5 and clicked edit, you would display the edit dialog with the
information for that interface.
Use these buttons to configure, edit, and remove subinterfaces from the selected
physical interface.
Add or edit a Bridge Group Virtual Interface (BVI) in this window. If your router
has a Dot11Radio interface, a BVI is automatically created when you configure a
new bridge group. This is done to support IRB bridging. You can change the IP
address and subnet mask in this screen.
Enter the IP address and subnet mask that you want to give the BVI.
This window enables you to add a loopback interface to the selected interface.
Select whether the loopback interface is to have no IP address or a static IP
address.
Chapter 4 Edit Interface/Connection
OL-4015-08