Configure Dsl Controller - Cisco OL-4015-08 User Manual

Configure DSL Controller

Configure DSL Controller
Controller Mode
Equipment Type
Operating Mode
Line Mode
Line Number
Line Rate
Cisco Router and Security Device Manager Version 2.2 User's Guide
4-32
SDM supports the configuration of the Cisco WIC-1SHDSL-V2. This WIC
supports TI, E1, or a G.SHDSL connection over an ATM interface. SDM only
supports a G.SHDSL connection using the ATM interface. This window lets you
set the controller mode on the WIC to ATM, enab ling a G.SHDSL connection,
and lets you create or edit DSL controller information for the G.SHDSL
connection.
SDM supports only ATM mode, which provides for a G.SHDSL connection, on
this controller. This field will automatically be set to ATM mode when the OK
button is clicked.
Select whether your connection terminates at the Central Office (CO) or your
Customer Premises Equipment (CPE).
Select whether the DSL connection should us Annex A signaling (for DSL
connections in the U.S.) or Annex B signaling (for DSL connections in Europe).
Select whether this is a 2-wire or 4-wire G.SHDSL connection.
Select the interface number on which the connection will be made.
Select the DSL line rate for the G.SHDSL port. If you have selected a 2-wire
connection, you can select either auto, which configures the interface to
automatically negotiate the line rate between the G.SHDSL port and the DSLAM,
or the actual DSL line rate. The supported line rates are 200, 264, 392, 520, 776,
1032, 1160, 1544, 2056, and 2312.
Chapter 4 Edit Interface/Connection
OL-4015-08