Configure Lmi And Dlci - Cisco OL-4015-08 User Manual

Configure LMI and DLCI

VCI
Cisco IOS Default Values
Connection Type Parameter
ADSL
•
G.SHDSL
•
•
•
ADSL over
•
ISDN
Configure LMI and DLCI
LMI Type
Cisco Router and Security Device Manager Version 2.2 User's Guide
3-16
Enter the VCI value obtained from your service provider or system administrator.
The virtual circuit identifier (VCI) is used in ATM switching and routing to
identify a particular connection within a path that it may share with other
connections. Enter the VCI value given to you by your service provider.
The values shown in the following table are Cisco IOS defaults. SDM will not
overwrite these values if they have been changed during a prior configuration, but
if your router has not been previously configured, these are the values that will be
used:
Operating mode
Operating mode
Line Rate
Equipment type
Operating mode
If you are configuring a connection with Frame Relay encapsulation, you must
specify the protocol used to monitor the connection, called the Local Management
Identifier (LMI), and provide a unique identifier for this particular connection,
called a data link connection identifier (DLCI).
Ask your service provider which of the following LMI types you should use.
Chapter 3
Value
Auto
•
Annex A (U.S.).
•
Auto
•
CPE
•
Auto
•
Create Connection Wizards
OL-4015-08