Cisco OL-4015-08 User Manual page 440

IDS Network Module Management
IDS Network Module Status
Cisco Router and Security Device Manager Version 2.2 User's Guide
20-2
Reset
Click to perform a reset of the IDS network module hardware You should only use
the Reset button to recover from Failed state, or after you have shutdown the IDS
Network Module.
Shutdown
Click to shutdown the IDS Network Module. You should always perform a
shutdown before you to remove the module from the router.
Launch IDM
Click to start the IDM software on the IDS module. When you launch the IDM
software, SDM displays a dialog box that asks you for the IP address of the IDS
module's external Fast Ethernet interface. When SDM obtains the correct address,
it opens an IDM window. For more information on this dialog box, refer to
Address Determination.
For more information on how to run the IDM application, refer to the documents
at the following link:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids10/index.htm
Refresh
Click to refresh the status display.
This area shows the general status of the IDS Network Module. It contains the
following types of information.
Service Module–The name of the network module.
•
State–The state of the network module. Possible states are: Steady state,
•
Shutdown, and/or Failed.
Software Version–The version of IDM software running on the module.
•
Model–The model number of the network module.
•
Memory–The amount of memory available on the network module.
•
Chapter 20 Network Module Management
IP
OL-4015-08