Set Scheduler Interval; Set Scheduler Allocate - Cisco OL-4015-08 User Manual

Fix It Page

Set Scheduler Interval

Set Scheduler Allocate

Cisco Router and Security Device Manager Version 2.2 User's Guide
16-16
The configuration that will be delivered to the router to disable SNMP is as
follows:
no snmp-server
Security Audit configures the scheduler interval on the router whenever possible.
When a router is fast-switching a large number of packets, it is possible for the router
to spend so much time responding to interrupts from the network interfaces that no
other work gets done. Some very fast packet floods can cause this condition. It may
stop administrative access to the router, which is very dangerous when the device is
under attack. Tuning the scheduler interval ensures that management access to the
router is always available by causing the router to run system processes after the
specified time interval even when CPU usage is at 100%.
The configuration that will be delivered to the router to tune the scheduler interval
is as follows:
scheduler interval 500
On routers that do not support the command scheduler interval, Security Audit
configures the scheduler allocate command whenever possible. When a router is
fast-switching a large number of packets, it is possible for the router to spend so much
time responding to interrupts from the network interfaces that no other work gets
done. Some very fast packet floods can cause this condition. It may stop
administrative access to the router, which is very dangerous when the device is under
attack. The scheduler allocate command guarantees a percentage of the router CPU
processes for activities other than network switching, such as management processes.
The configuration that will be delivered to the router to set the scheduler allocate
percentage is as follows:
scheduler allocate 4000 1000
Chapter 16 Security Audit
OL-4015-08