Cisco OL-4015-08 User Manual page 113

Chapter 4 Edit Interface/Connection
DLCI
LMI Type
OL-4015-08
Subnet Mask
If you selected Static IP address, enter the
specifies the portion of the IP address that provides the network address. This
value is synchronized with the subnet bits. Your network administrator or Internet
service provider provides the value of the subnet mask or the network bits.
Subnet Bits
Alternatively, enter the
provides the network address.
IP Unnumbered
If you selected IP unnumbered, the interface will share an IP address that has
already been assigned to another interface. Select the interface whose IP address
you want the interface you are configuring to use.
Enter the data link connection identifier (DLCI) in this field. This number must
be unique among all DLCIs used on this interface. The DLCI provides a unique
frame-relay identifier for this connection.
If you are editing an existing connection, the DLCI field will be disabled. If you
need to change the DLCI, delete the connection and create it again.
Ask your service provider which of the following Local Management Interface
(LMI) types you should use. The LMI type specifies the protocol used to monitor
the connection:
ANSI
Annex D defined by American National Standards Institute (ANSI) standard
T1.617.
Cisco
LMI type defined jointly by Cisco and three other companies.
ITU-T Q.933
ITU-T Q.933 Annex A.
Cisco Router and Security Device Manager Version 2.2 User's Guide
Connection: Serial Interface, Frame Relay Encapsulation
subnet
network bits to specify how much of the IP address
mask. The subnet mask
4-37