How Do I View The Ios Commands I Am Sending To The Router; How Do I Enable Or Disable An Interface - Cisco OL-4015-08 User Manual

How Do I...
How Do I...

How Do I View the IOS Commands I Am Sending to the Router?

How Do I Configure an Unsupported WAN Interface?

How Do I Enable or Disable an Interface?

Step 1
Step 2
Step 3
Step 4
Cisco Router and Security Device Manager Version 2.2 User's Guide
3-26
This section contains procedures for tasks that the wizard does not help you
complete.
See How Do I View the IOS Commands I Am Sending to the Router?
SDM does not support configuration of every
might support. If SDM discovers an interface in your router that it does not
support, or a supported interface with an unsupported configuration, SDM
displays a radio button labeled Other (Unsupported by SDM). The unsupported
interface is displayed in the Interfaces and Connections window, but it cannot be
configured using SDM.
To configure an unsupported interface, you must use the router command-line
interface (CLI).
You can disable an interface without removing its configuration, and you can
reenable an interface that you have disabled.
Click Configure on the SDM toolbar.
Click Interfaces and Connections in the left frame.
Click the interface that you want to disable or enable.
If the interface is enabled, the Disable button appears below the Interface List.
Click it to disable the interface. If the interface is currently disabled, the Enable
button appears in that location. Click that button to disable the interface.
Chapter 3 Create Connection Wizards
WAN interface that your router
OL-4015-08