Cisco OL-4015-08 User Manual page 143

Chapter 5 Create Firewall
DMZ Interface
To save this configuration to the router's running configuration and leave this wizard:
How Do I...
OL-4015-08
Apply access rule to the inbound direction to permit IPSec tunnel traffic if
•
necessary.
Apply access rule to the inbound direction to deny spoofing traffic.
•
Apply access rule to the inbound direction to deny traffic sourced from
•
broadcast, local loopback and private address.
Apply access rule to the inbound direction to deny all other traffic.
•
If you configured an Advanced firewall, this area shows you the DMZ interface
you designated, along with its IP address. Underneath, SDM describes what
access and inspection rules were associated with this interface. The following are
examples:
Apply CBAC inspection rule to the outbound direction
•
Apply access rule to the inbound direction to deny all traffic.
•
Click Finish. SDM saves the configuration changes to the router's running
configuration. The changes will take effect immediately, but will be lost if the
router is turned off.
If you checked Preview commands before delivering to router in the User
Preferences window, the Deliver configuration to router window appears. In this
window, you can view the CLI commands you that are delivering to the router.
This section contains procedures for tasks that the wizard does not help you
complete.
Cisco Router and Security Device Manager Version 2.2 User's Guide
How Do I...
5-11