Ping; Delete Connection - Cisco OL-4015-08 User Manual

Chapter 8 Site-to-Site VPN

Delete Connection

Delete the crypto map with sequence number n from IPSec policy policy name
Delete the dynamic crypto map with sequence number n from the dynamic crypto map set set name
Disassociate the IPSec policy policy name from the interface interface name , and keep the IPSec policy
for possible future reuse

Ping

Source
OL-4015-08
Use this window to delete a VPN tunnel, or simply to disassociate it from an
interface but preserve the definition for future use.
Click this button, and then click OK to remove the VPN tunnel definition. The
associations created between the interface, IPSec policy, and peer devices will be
lost when you do this. If more than one interface has been associated with this
tunnel definition, those associations are deleted as well.
This button is shown if you selected a dynamic site-to-site VPN tunnel. Click this
button, and then click OK to remove the VPN tunnel definition. The associations
created between the interface, IPSec policy, and peer devices will be lost when
you do this. If more than one interface has been associated with this tunnel
definition, those associations are deleted as well.
Click this button, and then click OK to retain the tunnel definition but remove its
association with the interface. You will be able to associate this definition with
another router interface if you wish.
You can ping a peer device in this window. You can select both the source and
destination of the ping operation. You may want to ping a remote peer after you
reset a VPN tunnel.
Select or enter the IP address where you want the ping to originate. If the address
you want to use is not in the list, you can enter a different one in the field. The
ping can originate from any interface on the router. By default, the ping command
originates from the outside interface with the connection to the remote device.
Cisco Router and Security Device Manager Version 2.2 User's Guide
Edit Site-to-Site VPN
8-65