Interface Status - Cisco OL-4015-08 User Manual

Interface Status

Interface Status
Monitor Interface and Stop Monitoring Button
Test Connection Button
Interface List
Select Chart Types to Monitor Group
Cisco Router and Security Device Manager Version 2.2 User's Guide
32-6
Informational
The number of log entries stored that have a severity level of 6 or higher. These
information messages signal normal network events.
The Interface Status screen displays the current status of the various interfaces on
the router, and the numbers of packets, bytes, or data errors that have travelled
through the selected interface. Statistics shown on this screen are cumulative since
the last time the router was rebooted, the counters were reset, or the selected
interface reset.
Click this button to start or stop monitoring the selected interface. The button
label changes based on whether SDM is monitoring the interface or not.
Click to test the selected connection. A dialog appears that enables you to specify
a remote host to ping through this connection. The dialog then reports on the
success or failure of the test. If the test fails, information about why the test may
have failed is given, along with the steps you need to take to correct the problem.
Select the interface for which you want to display statistics from this list. The list
contains the name, IP address and subnet mask, the slot and port it is located in,
and any SDM or user description entered.
These check boxes are the data items for which SDM can show statistics on the
selected interface. These data items are as follows:
Packet Input—The number of packets received on the interface.
•
Packet Output—The number of packets sent by the interface.
•
Chapter 32 Viewing Router Information
OL-4015-08