Mitsubishi Electric FR-F800 Series Instruction Manual page 584

NOTE
• When parameter settings are copied to the USB memory without specifying a parameter setting file number in the USB
memory, numbers are automatically assigned.
• Up to 99 files can be saved in the USB memory. When the USB memory already has 99 files, attempting copying of another
file to the USB memory causes the file quantity error (rE7).
• Refer to the Instruction Manual of FR Configurator2 for the details on importing files to FR Configurator2.
• While password protection is enabled, parameter copy and parameter verification cannot be performed. (Refer to
 Reading the parameter settings in the inverter and storing them in the
USB memory
Operating procedure
1.
Insert the USB memory device into the copy source inverter.
2.
USB memory mode
Press
3.
Displaying the file selection screen
Press
the USB memory, display the file selection screen, turn
4.
Reading to and storing in the USB memory
Turn
takes about 15 seconds to read and store all the settings. During reading, "
"
 Writing parameter settings stored in the USB memory to the inverter
Operating procedure
1.
Insert the USB memory device into the destination inverter.
2.
USB memory mode
Press
3.
Displaying the file selection screen
Press
4.
Selecting the file number
Turn
5.
Turn
6.
Writing to the inverter
Press
about 15 seconds to write all the settings. During writing, "
"
● Perform this step while the inverter is stopped.
7.
When parameters are written to the destination inverter, reset the inverter before operation by, for example, turning
the power supply OFF.
Downloaded from ManualsNet.com
to change to the USB memory mode.
three times to display "
to change to " ". Press
" and the file number are displayed alternately after the reading and storing are completed.
to change to the USB memory mode.
three times to display "
to select the file number to copy to the inverter, and press
to display " " and press
to start writing the parameter settings stored in the USB memory to the destination inverter. (It takes
" and the file number are displayed alternately after copying ends.
search engine
" (file selection screen) and press
to select the file number, and press
to start reading the parameter settings by the USB memory. (It
" (file selection screen).
.
. " " appears.
" blinks.)
5.16 Copying and verifying parameters using a USB memory
page 208.)
. (To overwrite files on
.)
" blinks.)
5. PARAMETERS
1
2
3
4
5
6
7
8
9
10
583