Mitsubishi Electric FR-F800 Series Instruction Manual page 546

Segmentation Capability:
Able to transmit segmented messages
Able to receive segmented messages
Standard Object Types Supported:
An object type is supported if it may be present in the device. For each standard Object Type supported provide the following
data:
1.
Whether objects of this type are dynamically creatable using the CreateObject service
2.
Whether objects of this type are dynamically deletable using the DeleteObject service
3.
List of the optional properties supported
4.
List of all properties that are writable where not otherwise required by this standard
5.
List of all properties that are conditionally writable where not otherwise required by this standard
6.
List of proprietary properties and for each its property identifier, datatype, and meaning
7.
List of any property range restrictions
Dynamic object creation and deletion is not supported.
To check the object types supported by the FR-F800 series, refer to
Data Link Layer Options:
ARCNET (ATA 878.1), 2.5 Mb. (Clause 8)
ARCNET (ATA 878.1), EIA-485 (Clause 8), baud rate(s)
BACnet IP, (Annex J)
BACnet IP, (Annex J), BACnet Broadcast Management Device (BBMD)
BACnet IP, (Annex J), Network Address Translation (NAT Traversal)
BACnet IPv6, (Annex U)
BACnet IPv6, (Annex U), BACnet Broadcast Management Device (BBMD)
BACnet/ZigBee (Annex O)
ISO 8802-3, Ethernet (Clause 7)
MS/TP master (Clause 9), baud rate(s): 9600, 19200, 38400, 57600, 76800, 115200
MS/TP slave (Clause 9), baud rate(s):
Point-To-Point, EIA 232 (Clause 10), baud rate(s):
Point-To-Point, modem, (Clause 10), baud rate(s):
Other:
Device Address Binding:
Is static device binding supported? (This is currently necessary for two-way communication with MS/TP slaves and certain
other devices.)
Networking Options:
Router, Clause 6 - List all routing configurations, e.g., ARCNET-Ethernet, Ethernet-MS/TP, etc.
Annex H, BACnet Tunneling Router over IP
Downloaded from ManualsNet.com
Window Size
Window Size
Yes No
search engine
page 537.
5.12 (N) Communication operation parameters
1
2
3
4
5
6
7
8
9
10
545
5. PARAMETERS