Mitsubishi Electric FR-F800 Series Instruction Manual page 582

5.15.2 Parameter verification
• Whether the parameter settings of inverters are the same or not can be checked.
Operating procedure
1.
Copy the parameter settings of the verification source inverter to the operation panel according to the procedure on
page
2.
Detach the operation panel from the source inverter and attach it to the verification target inverter.
3.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
4.
Selecting the parameter setting mode
Press
5.
Selecting the parameter
Turn
"
6.
Parameter verification
Turn
Press
verification destination inverter is started. (It takes about 60 seconds to verify all the settings. During verification,
"
● If there are different parameters, the different parameter number and "
● To continue verification, press
7.
"
NOTE
• When "
Downloaded from ManualsNet.com
579.
to choose the parameter setting mode. (The parameter number read previously appears.)
to " " (Parameter copy) and press
" appears.
to change to setting value "
. Verification of the parameter settings copied to the operation panel and the parameter settings of the
" blinks.)
" and "
" blinks, the set frequency may be incorrect. To continue verification, press
search engine
" (Parameter copy verification mode).
.
" are displayed alternately after verification ends.
5.15 Copying and verifying parameters on the operation panel
.
" are displayed alternately.
.
1
2
3
4
5
6
7
8
9
10
581
5. PARAMETERS