Mitsubishi Electric FR-F800 Series Instruction Manual page 473

5.11.13 Automatic restart after instantaneous power
failure/flying start with a PM motor
PM PM PM
When using the IPM motor MM-EFS or MM-THE4, the inverter operation can be restarted without stopping the motor operation.
When the automatic restart after instantaneous power failure function is selected, the motor driving is resumed in the following
situations:
• When power comes back ON during inverter driving after an instantaneous power failure
• When the motor is coasting at start
Pr. Name
57
Restart coasting time
A702
Automatic restart after
162
instantaneous power
A700
failure selection
611 Acceleration time at a
F003 restart
 Automatic restart after instantaneous power failure function
Power
ON
supply
IPF
∗1 10 to 100 ms for IP55 compatible models
• The inverter output is shut off at the activation of the Instantaneous power failure (E.IPF) or Undervoltage (E.UVT). (Refer
to page 594 for E.IPF or E.UVT.)
• When E.IPF or E.UVT is activated, the Instantaneous power failure/undervoltage (IPF) signal is output.
• The IPF signal is assigned to terminal IPF in the initial status. By setting "2 (positive logic) or 102 (negative logic)" in any
parameter from Pr.190 to Pr.196 (Output terminal function selection), the IPF signal can be assigned to another
terminal.
• When the automatic restart after instantaneous power failure function is selected, motor driving is resumed at the power
restoration after an instantaneous power failure or undervoltage. (E.IPF and E.UVT are not activated.)
 Connection (CS signal)
• When the Selection of automatic restart after instantaneous power failure / flying start (CS) signal is assigned to the input
terminal by setting "6" in Pr.178 to Pr.189 (Input terminal function selection), restart operation is enabled at turn-ON of
the CS signal.
• When the CS signal is assigned to an input terminal and Pr.57 Restart coasting time ≠ "9999" (with restart), the inverter
cannot be operated while the CS signal remains OFF.
NOTE
• Changing the terminal assignment using Pr.178 to Pr.189 (Input terminal function selection) may affect the other functions.
Set parameters after confirming the function of each terminal.
• If the CS signal is not assigned to any input terminal, solely setting Pr.57 enables the restart operation at all times.
• If the restart operation is selected, instantaneous power failure (E.IPF) is disabled while the fault output signal is output at an
instantaneous power failure.
• The SU and FU signals are not output during the restart. These signals are output after the restart cushion time passes.
• Restart operation is also performed after the inverter reset is released or after the retry by the retry function occurs.
472
5. PARAMETERS
5.11 (A) Application parameters
Downloaded from ManualsNet.com
Initial value Setting range
0
9999 0.1 to 30 s
9999
0 to 3, 1000 to
1003
0
10 to 13, 1010 to
1013
0 to 3600 s
9999
9999
∗1
15 to 100 ms
OFF
ON
OFF
search engine
Description
No waiting time
Set the waiting time for the inverter to perform a restart after restoring
power due to an instantaneous power failure.
No restart
Frequency search only performed at the first start
Frequency search at every start
Set the acceleration time to reach Pr.20 Acceleration/deceleration
reference frequency at restart.
Standard acceleration time (for example, Pr.7) is applied as the
acceleration time at restart.