Mitsubishi Electric FR-F800 Series Instruction Manual page 486

 Copying the PLC function project data to USB memory
• This function copies the PLC function project data to a USB memory device. The PLC function project data copied in the
USB memory device can be copied to other inverters. This function is useful in backing up the parameter setting and for
allowing multiple inverters to operate by the same sequence programs.
• Refer to page 78
Monitor mode
USB memory mode
Project data file number
(displays 1 to 99,
unrelated to the number
of files saved in the USB
memory device)
• The following data can be copied by copying the project data via USB memory device.
Extension
.QPA
.QPG
.C32
.QCD
.DAT
.TXT
NOTE
• If the project data of the PLC function is locked with a password using FR Configurator2, copying to the USB memory device
and verification are disabled. Also if set to write-disabled, writing to the inverter is disabled. (For details on the PLC function,
refer to the PLC Function Programming Manual and the Instruction Manual of FR Configurator2.)
Downloaded from ManualsNet.com
for an outline of the USB communication function.
Parameter setting mode
File type
Parameter file
Program file
Function block source information
Global text comment information
Project management information
Copy information
search engine
Function mode Fault history mode
Overwrite the inverter project data file onto the designated
file in the USB memory device.
Write the designated project data file of the USB memory
device onto a data file of the inverter.
Verify the designated project data file of the USB memory
device against the project data file of the inverter.
Copy from inverter to USB
memory device
Supported
Supported
Supported
Supported
Supported
Supported
Copy from USB memory
device to inverter
Supported
Supported
Supported
Supported
Not available
Not available
5. PARAMETERS
5.11 (A) Application parameters
1
2
3
4
5
6
7
8
9
10
485