Table of Contents
Advertisement
FRONT AND REAR BRAKE
MASTER CYLINDER ASSEMBLY
WARNING
All internal parts should be cleaned in
new brake fluid only.
Internal parts should be lubricated with
brake fluid when installed.
Brake fluid:
DOT #4
Front brake
1.Install:
Master cylinder kit 1
Circlip 2
Rubber boot 3
Plate 4
NOTE:
When installing the plate 4, push it in
securely to the shown position.
2.Install:
Master cylinder 1
NOTE:
Install the master cylinder bracket with the
"UP" mark facing upward.
Tighten first the upper bolt, then the lower
bolt.
Bolt (master cylinder bracket):
7 Nm (0.7 m • kg, 5.1 ft • lb)
3.Install:
Copper washers 2
Brake hose 3
Union bolt 4
Union bolt 4:
30 Nm (3.0 m • kg, 22 ft • lb)
6 - 31
CHAS
Advertisement
Table of Contents
