Table of Contents
Advertisement
REAR WHEEL
2.Measure:
Wheel runout
Refer to "FRONT WHEEL".
3.Check:
Spoke(s)
Wheel bearings
Oil seals
Refer to "FRONT WHEEL".
INSTALLATION
Reverse the "Removal" procedure.
Note the following points.
1.Lubricate:
Rear wheel axle
Bearings
Oil seals
Recommended lubricant:
Lithium soap base grease
2.Install:
Rear brake caliper assembly
3.Install:
Rear wheel
4.Adjust:
Drive chain slack
Drive chain slack:
35 ~ 50 mm (1.38 ~ 1.97 in)
Refer to "DRIVE CHAIN SLACK ADJUST-
MENT" in CHAPTER 3.
5.Tighten:
Nut (rear wheel axle)
Nut (rear wheel axle):
105 Nm (10.5 m • kg, 75 ft • lb)
6 - 10
CHAS
Advertisement
Table of Contents
