Table of Contents
Advertisement
FRONT AND REAR BRAKE
10.Check:
Brake lever operation
A soft or spongy feeling → Bleed the
brake system.
Refer to "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" in CHAPTER 3.
Rear brake
1.Remove:
Caliper protector
Pad pins 1
2.Remove:
Brake pads 1
Shim (piston side)
3.Measure:
Pad thickness a
Out of specification → Replace.
NOTE:
Replace the pad spring if pad replacement
is required.
Replace the pads as a set if either is found
to be worn to the wear limit.
Wear limit:
1.0 mm (0.04 in)
4.Install:
Brake pads (with pad shim)
Pad pins
6 - 17
CHAS
Advertisement
Table of Contents
