Table of Contents
Advertisement
CHK
BATTERY INSPECTION
ADJ
Use special care so that charging clips are
in full contact with the terminal and that
they are not shorted. (A corroded clip of
the charger may cause the battery to gen-
erate heat at the contact area. A weak clip
spring may cause sparks.)
Before removing the clips from the bat-
tery terminals, be sure to turn off the
power switch of the charger.
Change in the open-circuit voltage of the
MF battery after being charged is shown
in the figure. The open-circuit voltage is
stabilized 30 minutes after charging has
been completed.
Therefore, to check the condition of the
battery, measure the open-circuit voltage
30 minutes after charging has been com-
pleted.
3 - 51
Advertisement
Table of Contents
