Table of Contents
Advertisement
FRONT FORK
*********************************
Installing steps:
Install the rod puller 1 and attachment 2
to the damper rod 3.
Rod puller:
P/N. YM-01437
Rod puller attachment:
P/N. 90890-01436
Install the fork spring, spring seats and
collars.
Pull up the rod puller and set the rod
holder 1 between the locknut 2 and
spring seat.
NOTE:
Use the "B" -marked side of rod holder.
Rod holder:
P/N. YM-01434
Remove the rod puller and attachment.
Temporarily install the cap bolt.
Tighten the locknut.
Locknut 2:
15 Nm (1.5 m • kg, 11 ft • lb)
Remove the rod holder.
NOTE:
Be careful, this fork spring is compressed.
*********************************
15.Install:
Inner tube (to cap bolt)
Temporarily tighten the cap bolt.
16.Install:
Fork boot 1
INSTALLATION
Reverse the "REMOVAL" procedure.
Note the following points.
1.Install:
Front fork
Temporarily tighten the pinch bolts.
6 - 44
CHAS
Advertisement
Table of Contents
