Table of Contents
Advertisement
ENGINE ASSEMBLY AND ADJUSTMENT
9.Install:
Push rod 1 1
Push plate 2
Pressure plate 3
Plain washer 4
Nut 5
Spring 6
Bolts 7
NOTE:
Tighten the bolts 7 in a crisscross pattern.
Bolt 7 (pressure plate):
8 Nm (0.8 m • kg, 5.8 ft • lb)
10.Check:
Push lever position
Push the push lever assembly in the direc-
tion of the arrow and make sure that the
match marks are be aligned.
Not aligned → Adjust.
1 Match mark on the push lever assembly
2 Match mark on the crankcase
11.Adjust:
Push lever position
*********************************
Adjustment steps:
Loosen the locknut 1 .
Turn the adjuster 2 clockwise or counter-
clockwise until both match marks are
aligned.
Hold the adjuster to prevent it from mov-
ing and thoroughly tighten the locknut.
CAUTION:
Do not overtighten the adjuster 2 , as this
may eliminate the necessary free play
between the push rods.
Locknut 1 (push rod 1):
8 Nm (0.8 m • kg, 5.8 ft • lb)
*********************************
4 - 49
ENG
Advertisement
Table of Contents
