Table of Contents
Advertisement
CHECKING OF CONNECTIONS
CHECKING OF CONNECTIONS
Dealing with stains, rust, moisture, etc. on
the connector.
1.Disconnect:
Connector
2.Dry each terminal with an air blower.
3.Connect and disconnect the connector
two or three times.
4.Pull the lead to check that it will not come
off.
5.If the terminal comes off, bend up the pin
1 and reinsert the terminal into the con-
nector.
6.Connect:
Connector
7.Check for continuity with a tester.
NOTE:
If there is no continuity, clean the termi-
nals.
Be sure to perform the above steps 1 to 7
when checking the wireharness.
When replacing the CDI unit, be sure to
check its connector.
For a field remedy, use a contact revital-
izer available on the market.
Use the tester on the connector as shown.
7 - 5
–
+
ELEC
Advertisement
Table of Contents
