Yamaha TTR250L Service Manual page 86

STEERING HEAD ADJUSTMENT
5.Remove:
Bolts (handlebar) 1
Nut (steering shaft) 2
Speedometer 3
Upper bracket 4
Pinch bolts (upper bracket)
6.Adjust:
Steering head
*********************************
Adjustment steps:
Remove the lock washer 1.
Remove the ring nut (upper) 2 and
damper collar 3, then loosen the ring nut
(lower) 4.
Tighten the ring nut (lower) using ring nut
wrench 5.
NOTE:
Set the torque wrench to the ring nut
wrench so that they form a right angle.
Loosen the ring nut (lower) one turn.
Retighten the ring nut (lower) using the
ring nut wrench.
Avoid overtightening.
3 - 37
Ring nut wrench:
P/N. YU-33975
Ring nut-lower 4 (initial tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
Ring nut-lower 4 (final tightening):
5 Nm (0.5 m • kg, 3.6 ft • lb)
WARNING
CHK
ADJ