Table of Contents
Advertisement
REAR BRAKE ADJUSTMENT
2.Adjust:
Brake pedal height
*********************************
Adjustment steps:
Loosen the locknut 1.
Turn the adjuster 2 in or out until the
specified pedal height is obtained.
Turning in
Turning out
WARNING
After adjusting the brake pedal height,
visually check the adjuster end. The
adjuster end must appear within 3.0 ~ 5.0
mm (0.12 ~ 0.20 in) b.
Tighten the locknut 1
CAUTION:
Make sure that the brake does not drag
after adjusting it.
WARNING
A soft or spongy feeling in the brake pedal
can indicate the presence of air in the brake
system. This air must be removed by bleed-
ing the brake system before the motorcycle
is operated. Air in the system will cause
greatly diminished braking capability and
can result in loss of control and an acci-
dent. Inspect and bleed the system if nec-
essary.
*********************************
3.Adjust:
Brake light switch
Refer to "BRAKE LIGHT SWITCH ADJUST-
MENT".
3 - 30
CHK
ADJ
Pedal height is increased.
Pedal height is decreased.
Locknut 1:
18 Nm (1.8 m • kg, 13 ft • lb)
Advertisement
Table of Contents
