Table of Contents
Advertisement
ENGINE OIL REPLACEMENT
Engine oil replacement (without oil filter)
1.Place the motorcycle on a level place.
2.Warm up the engine for several minutes,
then stop the engine. Then place a recep-
tacle under the drain plug.
3.Remove:
Drain plug 1
4.Drain:
Engine oil
5.Remove:
Bolt 2 (oil filter cover-lower)
NOTE:
The oil filter cover is secured by three
screws. The lower one should be removed
so that the filter cavity will drain.
6.Inspect:
Washer (drain plug)
Damage → Replace.
7.Install:
Bolt 2 (oil filter cover-lower)
Drain plug
8.Remove:
Oil filler cap 1
9.Fill:
Crankcase
CAUTION:
Do not allow foreign material to enter the
crankcase.
Do not add any chemical additives.
Engine oil also lubricates the clutch and
additives could cause clutch slippage.
10.Install:
Oil filler cap
3 - 21
CHK
ADJ
Drain plug 1 (crankcase):
20 Nm (2.0 m • kg, 14 ft • lb)
Bolt 2 (oil filter cover-lower):
10 Nm (1.0 m • kg, 7.2 ft • lb)
Periodic oil change:
1.1 L (0.97 Imp qt, 1.16 US qt)
Advertisement
Table of Contents
