Table of Contents
Advertisement
FRONT AND REAR BRAKE
7.Install:
Pad spring 1
Brake pads 2
Pad pins
Pad pins:
18 Nm (1.8 m • kg, 13 ft • lb)
NOTE:
Install the brake pad (inner) with its a por-
tion aligning with b of the caliper.
*********************************
Installation steps:
Connect a clear plastic tube 1 tightly to
the caliper bleed screw. Then, place the
other end of this hose into an open con-
tainer.
Loosen the caliper bleed screw and push
the piston into the caliper with your fin-
ger.
Tighten the caliper bleed screw.
Caliper bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
*********************************
8.Install:
Caliper body
Bolts 1 (caliper body):
23 Nm (2.3 m • kg, 17 ft • lb)
WARNING
Proper hose routing is essential to insure
safe motorcycle operation.
Refer to "CABLE ROUTING" in CHAPTER 2.
9.Inspect:
Brake fluid level
Refer to "BRAKE FLUID INSPECTION" in
CHAPTER 3.
1 "LOWER" level line
6 - 16
CHAS
Advertisement
Table of Contents
