Table of Contents
Advertisement
FRONT AND REAR BRAKE
NOTE:
Install the brake hose as shown.
WARNING
Proper hose routing is essential to insure
safe motorcycle operation.
Refer to "CABLE ROUTING" in CHAPTER
2.
Always use new copper washers.
4.Install:
Brake switch
Spring
Brake lever
Brake lever cover
Mirror (right)
NOTE:
Apply lithium soap base grease to the pivot
shaft of the brake lever.
Rear brake
1.Install:
O-ring 1
Joint (brake hose) 2
Master cylinder kit 3
Push rod 4
Circlip 5
Dust boot 6
2.Install:
Master cylinder 1
Copper washers 2
Brake hose 3
Union bolt 4
Bolts (master cylinder):
23 Nm (2.3 m • kg, 17 ft • lb)
Union bolt 4:
30 Nm (3.0 m • kg, 22 ft • lb)
NOTE:
When installing the brake hose to the mas-
ter cylinder, make sure the brake pipe
lightly touches the projection on the copper
washer (lower).
6 - 32
CHAS
Advertisement
Table of Contents
