Using Data Sets - Siemens SINAMICS Series Operating Instructions Manual

Hide thumbs Also See for SINAMICS Series:

Table of Contents

9.1 Basic information

Using data sets

Copying a command data set

Set parameter p0809 as follows:

1. p0809[0] = Number of the command data set to be copied (source)

2. p0809[1] = Number of the command data to which the data is to be copied (target)

3. p0809[2] = 1

Starts copying.

Copying is finished when p0809[2] = 0.

Copying a drive data set

Set parameter p0819 as follows:

1. p0819[0] = Number of the drive data set to be copied (source)

2. p0819[1] = Number of the drive data set to which the data is to be copied (target)

3. p0819[2] = 1

Starts copying.

Copying is finished when p0819[2] = 0.

Uncommissioned data sets

Drive commissioning can be completed even if uncommissioned data sets (EDS, DDS) are

Uncommissioned data sets are marked as "uncommissioned".

The attributes are displayed in STARTER or in the expert list or OPs.

Activating these data sets is not permitted and any attempt to do so will be rejected with an

Assigning these data sets to a drive data set (DDS) is only possible by means of a

commissioning step (p0009 ≠ 0, p0010 ≠ 0).

If there is no DDS dataset with the attribute "commissioned", the drive remains in a controller

inhibit state.

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A