To Remove The Fpd+ Cover - Agilent Technologies 8860 Maintaining

13 Maintaining the FPD+

To Remove the FPD+ Cover

To Remove the FPD+ Cover

1 Gather the following:
2 Turn off the flame, then turn off the GC.
When turning off the GC, first turn off the flame to prevent condensation from dripping into
C AU T I O N
the jet and column.
Be careful! The detector may be hot enough to cause burns. If the detector is hot, wear
WAR N IN G
heat-resistant gloves to protect your hands.
3 Open the FPD detector top cover.
4 Loosen the screws securing the FPD cover to the top of the detector.
5 For a single wavelength FPD, remove the two screws at the bottom left of the cover.
6 Lift the cover off the detector.
212
• T-20 Torx screwdriver
Maintaining Your GC