Agilent Technologies 8860 Maintaining page 21

2 Removing Covers
To Remove the Electronics Cover
Electronics cover
GC front
Figure 4.
3 Loosen the two captive screws on the right side cover, slide the cover backwards, then
4 Loosen the captive screw located on the left side of the electronics cover.
5 Reach under the back of the electronics cover to release the clip holding it in place, then
6 Loosen the two thumbscrews in the tray below the PMT, and remove the two screws in the
7 Remove the tray from the electronics cover.
Maintaining Your GC
Loosen captive screws located on the right side of the GC
remove.
raise the electronics cover and remove.
back of the tray.
Loosen captive
screws on right side
Pneumatics cover
release button (on
both sides)
GC back
21