To Install The Fpd+ Cover - Agilent Technologies 8860 Maintaining

13 Maintaining the FPD+

To Install the FPD+ Cover

To Install the FPD+ Cover

1 Gather the following:
2 Install the cover.
3 Close the FPD detector top cover.
Maintaining Your GC
• T-20 Torx screwdriver
Single-wavelength detector:
a Start the two screws on the right side of the cover.
b Start and tighten the screws at the base on the left side.
c Tighten the screws on the right side.
Dual-wavelength detector: Install the cover (two screws).
215