Tools And Materials Required For Maintenance - Agilent Technologies 8860 Maintaining

1 About Maintaining the GC

Tools and Materials Required for Maintenance

Tools and Materials Required for Maintenance

Table 1
required to perform a maintenance procedure are listed in step 1 of each procedure.
Table 1
Common tools
Wrench, angled, septum nut
Wrench, open-end, 1/4-inch and 5/16-inch
Wrench, open-end, 9/16-inch and 7/16-inch
Wrench, capillary inlet
Flathead screwdriver
Column cutter, wafer, 4/pk
Driver, nut, 1/4-inch
T-20 Torx key or screwdriver
T-10 Torx key or screwdriver
3-mm hex key wrench
Electronic flow meter(s) or bubble meter(s) capable of calibrated measurements at 1, 10, and
100 mL/min flow ranges
Electronic leak detector
Magnifying loupe, 20X
Metric ruler
Bench vise (for setting Swagelok fittings)
Razor or sharp knife
Tweezers, or
thin needle-nose pliers
Needle-nose pliers
ESD wrist strap (for installing new components)
Gloves, heat-resistant (for handling hot parts)
Wooden cotton swab (for removing FID filters)
Tools and materials for cleaning procedures
Cleaning brushes—The FID cleaning kit contains appropriate brushes for cleaning detectors and
inlets
Cleaning brushes—For cleaning split/splitless inlet split vent fitting, FID and collectors
Jet cleaning wire (.010-inch)
Clean, lint-free cloth (to protect contamination-sensitive detector parts)
Small ultrasonic cleaning bath with aqueous detergent (for cleaning detector and inlet parts)
Maintaining Your GC
lists the tools needed for most GC maintenance procedures. The specific tools
Tools and materials for GC maintenance
Part number
19251-00100
*
8710-0510
8710-0803
G3452-20512*
5181-8836*
8710-1561*
8710-1807
8710-2140
8710-2411
430-1020
8710-0007
8710-0004
9300-1408
9301-0985
8710-1346
11