To Replace The Fpd+ Ignitor - Agilent Technologies 8860 Maintaining

13 Maintaining the FPD+

To Replace the FPD+ Ignitor

To Replace the FPD+ Ignitor

1 Gather the following:
2 Launch the GC maintenance wizard: Maintenance > Detector > Perform Maintenance >
Be careful! The detector may be hot enough to cause burns. If the detector is hot, wear
WAR N IN G
heat-resistant gloves to protect your hands.
3 Remove the FPD cover. See
4 Loosen the collet screw holding the cable assembly to the ignitor. Remove the collet and
5 Use a nut driver to loosen and remove the glow plug.
Maintaining Your GC
• Ignitor replacement kit, see
• Torx screwdrivers, T-20 and T-10
• 5/16-inch nut driver (or wrench)
Replace FPD Ignitor> Start Maintenance. Wait for the GC to become ready.
The wizard will guide you through the maintenance steps described below.
cable assembly.
• If using a 5/16-inch wrench, you may need to remove the exit tube assembly using a
T-10 Torx driver
"Consumables and Parts for the FPD+"
"To Remove the FPD+ Cover"
on page 204.
on page 212.
213